Recuperando un roboRIO usando el MODO SEGURO

Ocasionalmente un roboRIO puede llegar a corromperse hasta el punto que no se pude recuperar usando un encendido normal y procesamiento de imagen. Prendiendo el roboRIO en Modo Seguro puede permitir que el dispositivo se inicie correctamente.

Importante

These steps are not applicable to the roboRIO 2. Reimaging the SD card following roboRIO 2.0 microSD card imaging process will fully reformat the device.

Iniciando en Modo Seguro

A roboRIO with the status light and the reset button highlighted.

Para encender el roboRIO en Modo Seguro:

  1. Suministrar voltaje al roboRIO.

  2. Dejar apretado el botón de Reset hasta cuando el LED de Status se encienda (~5 segundos) luego soltar el botón de Reset.

  3. Entonces el roboRIO se iniciará en Modo Seguro (indicado por el LED de estatus parpadeando en grupos de 3)

Recuperando el roboRIO

The roboRIO can now be imaged by using the roboRIO Imaging Tool as described in Imaging your roboRIO.

Acerca del Modo Seguro

In Safe Mode, the roboRIO boots a separate copy of the operating system into a RAM Disk (the firmware). This allows you to recover the roboRIO even if the normal copy of the OS is corrupted. While in Safe Mode, any changes made to the OS (such as changes made by accessing the device via SSH or Serial) will not persist to the normal copy of the OS stored on disk.