# Step 1: Characterizing Your Robot Drive

Note

For detailed instructions on using the System Identification tool, see its dedicated documentation.

Note

The drive identification process requires ample space for the robot to drive. Be sure to have at least a 10’ stretch (ideally closer to 20’) in which the robot can drive during the identification routine.

Note

The identification data for this tutorial has been generously provided by Team 5190, who generated it as part of a demonstration of this functionality at the 2019 North Carolina State University P2P Workshop.

Before accurately following a path with a robot, it is important to have an accurate model for how the robot moves in response to its control inputs. Determining such a model is a process called “system identification.” WPILib’s System Identification tool can accurately determine such a model.

## Gathering the Data

We begin by gathering our drive identification data.

## Analyzing the Data

Once the identification routine has been run and the data file has been saved, it is time to open it in the analysis pane.

### Checking Diagnostics

Per the system identification guide, we first view the diagnostics to ensure that our data look reasonable:

As our data look reasonably linear, and the fit metrics are within acceptable parameters, we proceed to the next step.

### Record Feedforward Gains

Note

Feedforward gains do not, in general, transfer across robots. Do not use the gains from this tutorial for your own robot.

We now record the feedforward gains calculated by the tool:

Since our wheel diameter was specified in meters, our feedforward gains are in the following units:

• kS: Volts

• kV: Volts * Seconds / Meters

• kA: Volts * Seconds^2 / Meters

If you have specified your units correctly, your feedforward gains will likely be within an order of magnitude of the ones reported here (a possible exception exists for kA, which may be vanishingly small if your robot is light). If they are not, it is possible you specified one of your drive parameters incorrectly when generating your robot project. A good test for this is to calculate the “theoretical” value of kV, which is 12 volts divided by the theoretical free speed of your drivetrain (which is, in turn, the free speed of the motor times the wheel circumference divided by the gear reduction). This value should agree very closely with the kV measured by the tool - if it does not, you have likely made an error somewhere.

### Calculate Feedback Gains

Note

Feedback gains do not, in general, transfer across robots. Do not use the gains from this tutorial for your own robot.

We now calculate the feedback gains for the PID control that we will use to follow the path. Trajectory following with WPILib’s RAMSETE controller uses velocity closed-loop control, so we first select Velocity mode in the identification tool:

Since we will be using the WPILib PIDController for our velocity loop, we furthermore select the WPILib (2020-) option from the drop-down “presets” menu. This is very important, as the feedback gains will not be in the correct units if we do not select the correct preset:

Finally, we calculate and record the feedback gains for our control loop. Since it is a velocity controller, only a P gain is required:

Assuming we have done everything correctly, our proportional gain will be in units of Volts * Seconds / Meters. Thus, our calculated gain means that, for each meter per second of velocity error, the controller will output an additional 3.38 volts.